We don't bother bracing the corners. The last bunch I put down were old power poles set at 4-5' in an auger hole just slightly larger than the pole and tamped in with gravel. Thus far they haven't started leaning. All of our wire, springs, tensioners and a lot of the insulators are Gallagher. Avoid single nail insulators. They arc across the nail when you have a big energizer. 2 nail are better and the pin type are the best that I've found. We ran mostly 2 wire but I'd suggest going with 3 wire if you've got calves. They can either go under it if it's too high or through it if it's too far apart... With a good three wire setup you can then partition off blocks for them with poly wire as needed. All I ever do with posts, either wood or portable is space them to keep the wire off the ground or keep the sag out. I'm not big on adding extra. The wire doesn't meen a damn to the cows. It's the heat on the wire that stops them... Remember... Big energizer and get it grounded VERY well with several ground rods. The energizer should send out 10-20 joules. If you're not committed to spending the bucks on a good energizer, grounding it right and keeping the growth down somewhat on the fence rows, go with some form of non-energized fence.
I rather like electric myself. I ran down most of the pagewire with the dozer 7 or 8 years ago. We spent a few years of trying to maintain electric over top of bad pagewire too because the old man couldn't part with the pagewire... That just doesn't work. Go one way or the other.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
