When you say neutral feels like drive, does it actually want to pull the truck ahead??
How was reverse after the truck ran alittle, did it seem to be normal?
As for blown o-rings or gaskets, probably not it. The 47RE doesn t use any gaskets or orings in the valve body.
Usually a delay in reverse with a harsh engagement is the result of either converter drainback, a problem with the reverse band or direct clutches, or pump wear.
Depending on what was done for modifications it may or may not charge the torque converter in park. Stock setup, it doesn t. In park, oil just bypasses from the pump back to the pan. Once you move the shift lever out of park to rev the pump has to try and push oil back to the converter, plus engage the rev band and direct clutches. This is where the delay comes in.
Try this, after the truck has sat over night check the trans fluid before you start it. If the converter is draining back, it will be high on the stick. Start the truck, let it idle in neutral for 30 seconds or so, then try reverse.
If it seems OK, then it would point to either a pump issue, pump bushing wear, or a converter problem. A problem with the converter would make the most sense if the RPM are dragging down in neutral.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.