Someone can borrow my idiot sticks too. Not bad for a 6" hole to 30" deep. Any deeper and it doesn't want to clean the hole unless you widen it out to about 12" in diameter. For most posts, I don't want to go wide enough necessary for the handles to spread. For narrow 6" holes going 36"+ deep, I have a round auger head mounted on a tee handle pipe. Go so far with the clam shell until you can't spread them any more then finish out the hole with hand auger. OK for a few holes at a time but mud really gums up the works and sticks to the metal. Spend more time and effort cleaning mud off the clam shells and the auger than the actual digging of dry soil. With a second guy to trade off not so bad. At least with the clamshell, I quit when my arms get tired and no clock is ticking on the rental. They need to be sharp for hard clay.
Besides, for less than the price of the rental, I own the digger. He who dies with the most tools in the shed wins.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Talk of the Town: How to Remove a Broken Bolt - by Staff. Another neat discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: "I have an aluminum steering gear housing with a bolt broken off in it. The bolt is about a 3/8" x 1 1/2" bolt. I've already drilled the center of the bolt out with about 7/64" drill bit the entire length of the bolt. Only one end of the bolt is visible. I tried to use an easy out but it wasn't budging and I didn't want t
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
