Posted by bc on April 18, 2009 at 08:18:52 from (71.158.222.135):
In Reply to: JD 148 Loader posted by JD in KS on April 18, 2009 at 06:58:12:
To get it in the bed of a pickup, a 7' bucket will have to be taken off and will lay lengthwise and the end on the tail gate, I'd think, with the front loader cross arm laying in front of it and stradling the loader. One brace may have to lay on top of the bucket. On a trailer you can leave it together and let it sit till ready to mount it. Without measuring one, I'd suspect it is going to lay across the wheel wells for sure.
I'd think you want to get some pictures and measurements before you go. I'd like to hear more details from the earlier poster who did haul one on how he got it all loaded.
Of course the extra gas and pulling a trailer is a pain for a long drive. I'm a one hand driver who tends to weave over the road with the wind and only correct every so often. My trailer is 8 1/2' wide (the max) and a lot wider than the pickup. It is a real pain pulling it down some of these 2 lane black tops and even bad on the interstate particularly going through big cities in multiple lanes. Constant 2 hands on the wheel and constant checking the mirrors since I only have a couple feet lane clearance on each side and then have a lane filling semi on each side of me going down the interstate making all those curves they have in the big cities at 70 mph. No fun and no relaxation.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Timing Your Magneto Ignition Tractor - by Chris Pratt. If you have done major engine work or restored your tractor, chances are you removed the magneto and spark plug wires and eventually reached the point where you had to put it all back together and make it run. On our first cosmetic restoration, not having a manual, we carefully marked the wires, taped the magneto in the position it came off, and were careful not to turn the engine over while we had these components off. We thought we could get by with this since the engine ran perfectly and would not need any internal work. After the cleanup and painting was done, we began reassembly and finally came to t
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.