Posted by Leroy on April 20, 2009 at 03:22:25 from (216.201.38.19):
In Reply to: Speed up an M farmall posted by 45M-meathead on April 19, 2009 at 05:05:43:
From what I understand they give 4 more speeds between the 4th and 5th gears so that raking hay when you can idle along and have enough power you could still have enough speed so you did not have to race the engine and in that speed range high normal 5th was too fast to pull loaded wagons but a speed faster than a normal 4th gear would have you could put in 4th high range and go down the road at a decient speed. Never ment to be used with the pto like a sherman in a Ford was never ment to be used with pto. The John Deere 6 speed transmission was slightly slower than the 5th speed in a Farmall and 4th was the same in both so there was a gap in Farmal gearing that equaled the 5 & 6 speeds in a Deere so those were designed to take up that gap and in the Deere 5th was correct for a hay rake. In other words normal 4th too slow for certain jobs and 5th too fast so you could put in the new 5th, 6, th, 7th, 8th and get a speed you had the poer to work at but enough or not too much speed. They did not speed up the normal 5th gear, only the normal 1st, 2nd, 3rd & 4th gears.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
