was lokking over some old invoices just this evening from when dad was in used car buisness for a couple of years,heres some prices he sold cars for in 77..65 mustang 289engine 4spd-$550,,67 mustang 302 as i recall auto-$300,,68 mustang engine unknown-$600,and took a rambler,a pontiac tempest,a 67 olds and a 64olds in in trade,,,58 apache chevrolet pickup large back glass small block v8 3speed-$100,,,67 chevrolet two door fastback-$300,,hauled @ 6 65-69 mustangs to scrap iron,,56 buick-sold to me-$25,,62 ford-he drove this car himself until it was stolen-he bought it for $60,,,67 ford galaxie two door hard top- he bought it for $20,I still have it and its going to be my rebuild project(someday)..made a totall of $2495 in 77 in spare time selling and fixing cars.not too bad considering his full time job brought in 15,000!!my total salary that year in the buisness?$70..lol..20 of that was for putting a engine in a 65 mustang,wouldnt have got that but he bet my bro in law and i we couldn't do it in 30 mins,had the old one out and the new one fired up in 15mins with bro handing tools!.brother drove that car until the doors literally fell off!my favorite,was the 57 58 ford two doors,still the best looking cars ford ever built in my opinion! wish i'd have kept all of them and sold them now!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
