Posted by jackinok on April 22, 2009 at 17:44:40 from (208.114.33.5):
In Reply to: Shallow wells posted by DAVE SHERBURNE NY on April 22, 2009 at 16:15:29:
how you jet a well,get the biggest pump you can find.cut your well pipe into say 5' piecesand thread for couplings( not really neccesary but you can work from ground instead of a scafollding).build a tri pod,a frame ,heavy tree limb,whatever you can use to lift pipe up and down.hook water to top of pipe and start pumping(youll need lots of water) and simply work pipe up and down.it helps to turn it sometimes.if it gets tight somewhere pull it back up and work through tight spots until it loosens up.HOWEVER!!!if you have gravelthat close to surface you would probably be better off driving one,how deep is reliable water normally do you think?gravel makes it harder however you try to go because it will collapse on you.I have seen back a lot of years ago,a man use a feed auger to put one in in loose gravel with a piece of single wall vent pipe as casing.he simply took a five foot piece of vent pipe,cut auger off in sections to fit it a bout a ft longer with a motor to turn auger.slid vent pipe over auger and started turning,lowered it very slowly as vent pipe worked itself into hole of its own weight.as he got to top of vent pipe he added another piece and welded on another piece of auger.he was in very small gravel and he went good and slow but it worked!he kept pipe full of water to help with digging and if it tried to bind he would pull auger and empty rocks to help take load off.dont recall how deep he went but it wasnt far.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
