|
Tractor Talk Discussion Board |
mowing techniques
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Leon Kasdorf on September 05, 2000 at 11:20:57 from (152.163.165.148):
This may sound like a pretty obvious, trivial issue, but it strikes me that there may be many techniques for mowing a large area with a tractor. I have a Ford 650 and a bush hog. Speficially, I am talking about an irregular area, where a linear back and forth approach is impractical. I tend to do a big spiral, avoiding "details" as much as possible. This all works fine, but when I have to go around a corner that is tighter than the turning radius of the tractor, I overshoot it, then come back in and undercut it. This evolves into a big "lobe". At times, to avoid this, I'll round off the corner to a gradual curve so I can get the bulk cut. Then, I'll go back and finish the cut-off corners (is this where the phrase "cutting corners" comes from). When it gets down to a small, wierd shape in the center of the lawn, that has corners that I cannot negotiate, I'll cut straght past the corner, then do a 270 degree turn to approach the next side. This seems easier than backing up and doing a Y turn. This is actually a large lawn, so I like to keep the mowing pattern as regular as possible. I'm just curious if anybody has any words of wisdom on this subject.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: 1951 Farmall H - by The Red (John Fritz). I have been a collector of Farmall tractors since 1990 when I first obtained part of the family farm in Eastern Indiana. My current collection includes a 1938 F20, 1945 H, 1946 H, and the recently purchased 1951 H. This article will focus on what I encountered and what I did to bring the 1951 NEAR DEATH Farmall H back to life.
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
