Posted by RayP(MI) on April 30, 2009 at 05:49:45 from (207.241.137.116):
In Reply to: Pull Disc vs 3-point posted by fregienewbee on April 30, 2009 at 04:26:47:
I have both, and I prefer the pull type - wheel disk for results. It seems to level better, and cut (dig) better. With the wheels, it will also float better, keeping the depth of cut more uniform. Manuvering is not a problem, if your drawbar is far enough behind the tractor rear wheel line. I can turn awfully short with mine. If your tongue and the tractor drawbar are set properly, the disk will run pretty much level, front to back.
Three point hitch disk is heavy enough that I have a 200# rock mounted on front of tractor just to keep the front wheels on the ground in transport situations. You will need to adjust your top link just right to get even penetration front to back. I find that I want to add extra weight to the 3pt disk to keep the rear gang cutting deep enough. This just adds to the front-rear weight problem. Trying to steer the tractor when front wheels are bouncing along or off the ground can be an adventure! Haven't needed to add weight to the pull-type. Unless your 3pt has a float position, you will also experience problems when you drive over uneven hills and valleys in your fields. But if you're floating the disk, then you don't really have good control of the depth and penetration. Not all of us are blessed with table-top fields.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.