Posted by thurlow on May 05, 2009 at 11:37:02 from (74.177.51.238):
In Reply to: Truck Flatbeds posted by Iowa Farmer on May 05, 2009 at 09:19:10:
Last'un we had wuz one I built; my Dad bought a new '82 one-ton Dodge cab and chassis.....4 speed/4-wheel drive/360. I built the bed, framed with 4 inch angle/diamond plate bed; rounded the corners, rather than squaring them off. Had a 'trap door' for the frame-mounted goose-neck hitch. He had a 400 bu. Howle grain trailer he pulled with it, 'though usually loaded to about 325 bu. I highly recommend building your own.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.