Posted by Bill in IL on May 06, 2009 at 07:09:41 from (131.43.10.190):
In Reply to: Re: A/C help again posted by Bob on May 06, 2009 at 06:36:58:
Yes I did evacuate the system before charging.
Engine RPM was 1600 with enough airflow to blow my hat off my head.
Thanks for the tip on the sightglass. Didn't know that one. But either way the low pressure side is too low and could see it on the line going to the cab as it was icing up.
Seems simple but there has to be something I am missing and I am no A/C expert.
I was told not to exceed 150 psi when charging a system and pushed it a little hoping it would stabilize and come down. But after running it a good 15 min after adding refrigerant it didn't come down any.
In the cab I was getting 12-13 degree drop in temp from fan inlet to outlet
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
