Posted by Doug - Iowa on May 11, 2009 at 08:56:29 from (71.32.179.33):
In Reply to: Old Semi Trailer posted by super99 on May 11, 2009 at 04:27:02:
I've had real good luck with mine. I poured two pads 2' wide x 2' deep x 8' across with plenty of rebar. Put a loop of rebar up on both ends of each pad. Located one pad so the front plate would set on it just behind the kingpin. Located the back one to set on frame between the wheels. Lifted the front up and torched out the landing gear, set it down then lifted the backend and torched out the axles and springs, and set it down. Once I had it all set I ran a cable up over the frame and tied it down to the loops in the pads so the wind din't blow it over. Has set there 10 years and been great storage. PS - I sold the axles and tires to make hay trailers out of that paid for the concrete.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
