Posted by justanothercase on May 12, 2009 at 16:31:23 from (72.20.68.231):
would have posted sooner but have been super busy so im not on the computer much. We got the tractor out on saturday without problems. used two achor points(payloader and four wheel drive with dozer) and a couple cables and pulley system and pulled it right up what was left of the bridge after torching the hitch off the air seeder. didnt take any pics was too busy helping to get everything set up, im supposed to be getting some emailed to me and i will post when i get them. after tractor was out they just filled in with dirt until the payloader would get under the seeder and picked it up and put it back on the road.
Tractor wasnt hurt too bad front cast broke and frame will need to be straightened or cut out and new welded in as it banana'd out on both sides, wreck some ac stuff, and bent the drawbar slightly up. they got pretty lucky, especially since noone got hurt when it fell and getting everything back out.
Allen in NE asked where it happened, it was about 15 miles southwest of Hettinger, ND right on the south dakota side of the border.
sorry for the long post just trying to cover as much as i could.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
