I always put a stack of round bales in the back of the barn, or dumped 12 feet from the back, let the top tip off and rick it against the back of whats left to leave me something to dump against.
After that, just make sure the rolling rack barely clears the previous stack so it stacks solid and use the stack poles. I'd normally put a tie tier in 4 and set for 2 bale on the last tier. That tied the stack tighter and losing one bale per load was easier than fooling with stack poles. I would check my load during dumping 3-4 times per dump for the first 20-25 loads of the season just to make sure I knew where I had it placed. Takes a while to get the hang of it. I made nothing but messes my first year with a NH bale wagon. After that I got pretty good at it.
If the bottom bales are pulling out on the face of the stack, make sure the tips arent bent on the rolling rack. I normally had to straighten mine at least once a week. If the center of the stack is bulging, check the bushings on the second table pivots. When they get worn the load rack stack doesnt get in right. About every 700-900 loads mine needed replaceing.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
