Posted by buickanddeere on May 14, 2009 at 19:26:59 from (216.183.134.54):
In Reply to: Dirtiest jobs posted by Mark W. on May 14, 2009 at 09:43:26:
I took a candu reactor fuel channel TSS inspection tool that was fresh from sliding down a fuel channel. Disconnected it from the delivery robot.Wrapped it in plastic and carried it from the reactor vault and placed it on a cart. Then it was taken to decontam and then the rubber parts/seals were replaced. After 30 minutes in the reactor core the highest quality, radiation resistant rubber deteriates into what looks like old sun exposed car tires. We ended up bring a couple of "fuel fleas" out with us plus having about 600,000 counts on out plastic suits. The little jerks kept hopping around until we found them and trapped them with duct tape.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
