Tractor Talk Discussion Board |
Re: 6 to 12 volt conversion
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jon Hagen on September 24, 2000 at 21:44:43 from (63.160.195.16):
In Reply to: 6 to 12 volt conversion posted by Gerald Lee on September 24, 2000 at 19:54:24:
First thing is make sure the battery is installed for neg ground. If you have a one wire alternator you need to run a 10 or 12 guage wire ( depends on the amp rating of the alternator) from the bat terminal on the alternator rear to one post of the amp guage. You hook the light switch to this same terminal. Run another 10 or 12 guage wire from the other amp guage terminal to the pos battery terminal( a good place is at the starter switch). If the amp guage reads backwards you need to switch the wires to the oposite post on the guage. If the alternator is a Delco 10 SI with one wire regulator that has not been used for a while you may have to flash the field to get it charging. The safest way to do this is get a replacement GM alternator plug( 74-85) at an auto parts store and plug it into the #1-#2 slot in the alt side, with the engine running at idle touch both wires from the plug to the bat terminal on the alt rear. If you need to do this field flash trick every time you start the tractor you may not have a 1 wire alternator, in that case you need to permanently wire the #2 wire in the alt plug to the bat terminal, and the #1 wire to a toggle or push button switch to connect it to the battery. With a button switch you need to push it for a moment after starting the tractor to start the alternator.With a toggle switch you must remember to turn off the switch when you park the tractor or the next day you will have a dead battery. If your alternator is other than a Delco, post what it is and I will try to help with wiring.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tuning-Up Your Tractor: Plugs & Compression Testing - by Curtis Von Fange. The engine seems to run rough. In the exhaust you can hear an occasion 'poofing' sound like somethings not firing on all cylinders. Under loaded conditions the tractor seems to lack power and it belches black smoke out of the exhaust. For some reason it just doesn't want to start up without cranking and cranking the starter. All these conditions can be signals that your unit is in need of a tune up. Ok, so what is involved in a tune up? You say, swap plugs and file the points....now tha
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|