Posted by Billy NY on May 24, 2009 at 09:54:21 from (74.67.3.238):
Anyone familiar with 3150's, I've been helping my friend getting the crops planted, we're done now and was trying to figure out a problem with the engage/disengage of the FWA on this 3150. Darned thing won't come out of FWA, annoying when you have to take er on the road, can't be all that good for it etc. 1st the wires came unplugged off the vickers component/part valve on the pan, he says he's got a book for the 3150, but I have not seen it yet, so I have no idea where the ground and or the other wire goes, only 2, but the vickers part has 3 blade terminals.
He calls me yesterday, he went and bought a new vickers part, it looks like some sort of valve with a screen on the end, magnetically operated ? Well the old one came out and the inside came out in pieces, the new one slid right in, we fooled with the wire connections, I could not see the light on the dash light up for either position, driveshaft and u-joints up at the front axle kept spinning and it has that tire rubbing noise in a tight turn, been doing that, so I still think it's engaged, not sure what to make of this, butg would at least like to figure out what blade terminals the wires connect too, and if that 3rd wire is missing or is not used. Any suggestions ?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
