|
Tractor Talk Discussion Board |
Re: snow plows, Interchangeable?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Scott Stratton(N.Y.Puller) on September 28, 2000 at 20:45:16 from (216.42.66.126):
In Reply to: snow plows, Interchangeable? posted by Steve/PA on September 25, 2000 at 13:37:30:
Steve, In my views as a young redneck...Any plow will fit..As I got a Cub Cadet Plow and under mount. and without a Cub...Oh What the heck It was a bit larger then the wittle 5 horse Dynamark Yet it worked for our snow last year up here. I Only gave 35-40 for the plow and under frame unit, yet I didn't get the side arm that lifted it..So I the Proud redneck Placed a Rope to a Leaver on the top of the hood...WORKED great...Though to heavy in the front...As what year and so on it came from..I have no Clue. I Can Messure it out for you tomorrow in the daylight if ya wish. As I have to many toys around here now, with two junked out dynamarks out back and my three baby's Wheel Horse's in the front year in a fenced in yard. . I Like all GUYS Just Loves ta tinker around....So Drop me a line, I am sure wife won't mind me Partin' with the Plow....
Talk with ya soon .. Or just drop me a E-mail at
scott_stratton@hotmail.com
As I don't stop in this site much, as I am normally just in Garden Tractors.
Sincerely: Scott Stratton
Plow is Right along route 17 Near Bath New York..
Take care
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
