Posted by MarkB_MI on May 25, 2009 at 04:17:18 from (216.234.123.175):
In Reply to: Cracked coil, why? posted by erikyater on May 24, 2009 at 21:40:15:
I have seen this happen with a 12 volt conversion where there was no resistor in the circuit. I would also expect to have problems with points burning up. But sometimes coils simply fail, due to heat and vibration. If you can't find a resistor between the coil and ignition switch, replace the coil with one that specifies "12 volt no external resistor required".
At the risk of starting a flame war, I'll mention a myth that's often repeated here: Supposedly a "true 12 volt coil" is superior to using a coil with an external resistor. Fact: it makes no difference whether the resistance is internal to the coil or external to it. The coil's energy is the same in either case.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Trenching With a Plow - by Staff. Introduction: This interesting information came from one of the discussion forums here at YT. We thought we should place it up front so it could be read by anyone interested in putting old iron to work. [Editor] I tried something new today, and it worked so well I thought I should post it - in case it might help someone else. I'm running 100 yards of 4" drain pipe from the gutter downspouts of our house to a pond down the hill. This should hel
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
