Tractor Talk Discussion Board |
Re: more questions re smokin'oil
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by ltf in nc on October 12, 2000 at 08:27:02 from (206.228.214.112):
In Reply to: more questions re smokin'oil posted by Carla Ricci on October 11, 2000 at 19:02:53:
response by question number 1) not knowing where you are located and the history of the tractor.. 30 WT non detergent...20 WT north of the mason dixon line 3)pounds per square inch on each cylinder as the engine now sits and pounds per square inch of each cylinder after squirting a few squirts of oil in each cylinder 5) depends..need to do the compression test first. You could do excessive damage if a piston has a hole in it or a valve has dropped 6) A standard muffler and pipe for this tractor is cheap and readily available for approx. $20 7) Grade 5 bolts of the correct size will be fine from any source
Follow Ups:
Home
| Forums
Today's Featured Article -
Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|