Posted by Bernie/MA on June 11, 2009 at 17:50:44 from (159.250.60.169):
In Reply to: OT Welding Question posted by super99 on June 11, 2009 at 16:59:36:
I still have and use the Lincoln 180 that I bought new in 1955. I read how to weld vertical but had to see it done before I had much luck. I'd use 7014 rod and practice on scrap first starting from the bottom and going up. Set up a corner and strike the arc at the bottom left (if you're right-handed). Have the rod slanted with the tip upwards if you can. Move across to the right as soon as the puddle forms, hesitate a bit and move upward on that side a half-inch or so, hold it long enough for the lower puddle to set up and turn dark and go back down to just above where you started and repeat. You can have the heat about the same as for flat welding or a little lower. Keep a close arc but back off a little at the top of the upstroke, as I remember. It's been a while.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulic Basics - Part 2 - by Curtis Von Fange. In the last entry to this series we gave a brief overview of hydraulic system theory, its basic components and how it works. Now lets take a look at some general maintenance tips that will keep our system operating to its fullest potential. The two biggest enemies to a hydraulic system are dirt and water. Dirt can score the insides of cylinders, spool valves and pumps. Wate
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
