Posted by s.crum on June 13, 2009 at 04:47:49 from (4.156.231.68):
In Reply to: OT Mechanics posted by John B. on June 12, 2009 at 20:52:11:
I finished high school along with 3 years of tech school. I'm saddened everyday to hear of kids dropping out of high school, but agree there are a few valid reasons for doing so. I'm a shift supervisor that certainly does not have a college degree as a back up. I've seen literally dozens of "college educateds" come and go, many being "too good" for that kind of work, some being very good and moving up, and the rest you must wonder "how do they function"? I entered my current job with 14 years of shift management experience, that was after a half dozen job interveiws where I was told ' man we could really use your skills but without a degree we cannot use you'. My current plant manager hired me based on the 'hit the floor running' skills I had. He stated that a degree would be nice but somebody that can come on line in days rather than months or years is considerably more valuable. As far as mechanicin' I've seen a lot of wrench benders that didn't have the 'education' and $20,000 Snap-on tool box that I'd stake my life on. On the otherhand I've seen the opposite. I've had a new hired industrial electrican in a non-union shop stand there and tell me that lugging wires together in a motor box was a millright's responsability. You may wonder what an old school shift boss has to say to him right after said shift boss just helped muscle the 200 horse motor in to place and tie it down. I agree you have meatheads at all education levels, but I've seen just as many "educated mechanics" stand there and hammer a wheel on a car with a thundergun so tight it will never come off (or run true again) as I have dropouts. Most interveiwers toss out applications that don't have at least a GED listed on them these days.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let’s make one more addition to our series on hydraulics. I’ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
