Posted by andy r on June 29, 2009 at 20:21:57 from (67.224.8.75):
In Reply to: OT chevy car advise posted by F150Mustang on June 29, 2009 at 18:53:59:
I have a 2005 Chey Monte Carlo. I thought I had warp rotors on front too. It needed brakes as one of the pads separated from the steel backing. So, for $30 for each rotor and $25 for a set of "better that orginal equipment" pads I replaced everything on front. Just like you I still have the pulse when I brake hard. The rear brakes are disk also so I think they need to be replaced as well. I haven't taken the time to study the brake system that well on this car, but I do know some cars have a master cylinder in that one piston feeds the front and one piston feeds the back. Some cars feed the wheels diagonally (front right and rear left / front left and rear right). I just thought about that and how if the rear left was warped how that might feed back through the lines to the front right. I don't know that to be a fact. Anyway, like you my car still has that pulsing even after new front pads and rotors. Any help would be good. Thank you.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
