Tractor Talk Discussion Board |
Massey Harris Engine Rebuild
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Quick on November 02, 2000 at 06:07:03 from (208.5.114.123):
I have a 1949 massey harris tractor with a F162 continentail engine and it requires a rebuild. The pistons are presently .060 oversized and the last cylinder has a crack in the wall, I have placed a .010 feeler gage per the jensen repair manual between the piston skirt and cylinder, this has a tight fit. The jensen repair manual states the cylinder is good if you don't exceed the .010 feeler gage. My biggest problem is with the last cylinder that has the cracked wall, do I sleeve this to the standard size or do I sleeve all the cylinders to standard size. Can someone give some insight how to proceed with the engine rebuild. Just for a note, when I removed the piston rings from the piston and placed the top ring in the cylinder to see the gap remaining was approx. 1/8". This tells my the rings are worn or someone did a fast ring job and used the wrong size piston ring. The only reason I thing someone did a fast ring job is the connecting rod cotter keys were missing from some of the connecting nuts.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford N-Series Transmission/Hydraulic Fluid - The Full Story - by Llamas. The transmission fluid in an “N”:-series tractor lubricates the transmission, differential, rear wheel bearings, PTO and hydraulic pump drive, and it also cats as the working fluid for the hydraulic lift. In 9N/2N models, it also lubricates the steering sector and shaft system. The owner’s manual for the 9N and 2N models specified the use of only two fluids. They were STRAIGHT MINERAL OIL SAE 90 (above freezing) and
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|