Tractor Talk Discussion Board |
Re: OFF TOPIC - but I know you guys can help !!! Painting Problems.
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken McWilliams on November 05, 2000 at 20:04:28 from (152.163.197.67):
In Reply to: OFF TOPIC - but I know you guys can help !!! Painting Problems. posted by Alberta Mike on November 05, 2000 at 16:50:06:
Mike, Bubbles are indicative of something volatile under the paint wanting to escape. Perhaps the primer is not yet dried. First, if you have done some patching, the solvents may be wanting to escape from the filler. Second, using a water borne latex this time of year, the paint will skin over due to low humidity. Then, the paint under the skinned over area will volatilize and cause blistering. You may want to roll it out a little thinner, and use multiple coats. Third, porosity in the wall may be causing a problem. Trapped air wanting to escape through the new paint layer. Fourth, a slim chance, but if rolling on too fast may be trapping air. Roll the area very well when applying paint before going on to the next area of application. Fifth, if you used a solvent to wash down the wall before painting, the solvent now is being released and causing bubbles. Sixth, if you are directing some heat toward the wall, the paint will skin over too fast before the paint under it has a chance to lose its volatile vehicle (solvent). Take your time. Forget tractors for a while until the paint job is finished. Gotta make the wife happy and buy some tractor time from her. Unfortunately, most of the help at the stores are nothing more than warm bodies to man the cash register. Ken McWilliams Dayton, OH
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|