Tractor Talk Discussion Board |
Re: Froze-Up engine
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Salmoneye on November 10, 2000 at 16:18:25 from (206.27.102.56):
In Reply to: Froze-Up engine posted by clarence E. Causey III on November 10, 2000 at 15:34:22:
I'll take a shot at this... It is usually the rings to the cylinder walls. However, it is possible that other points can be stuck, (such as the crank to the bearings or valve stems to the guides). If the WD-40 does not free up the rings, try 2 days with PB Blaster and try the hand crank again. Make sure that when you are trying to crank by hand that you have the plugs out so you are not working against the engine compression! If that doesn't do it, pour about 2 tablespoons of Marvel Mystery Oil in each cylinder and let it sit for a week and then try the crank. If you can get a straight shot at the valves with the 'straw' for the WD-40, hit them good too. If all else fails, you can of course try and pull her in gear. Do not push in on the clutch and then pop it once you are going, but just try and pull it with it in gear and the clutch engaged. Do not try and start it at first, you just want to free it up. If you are just dragging her, then I would say it is time to pull the head at least. I also have had success by putting it in the highest gear and rocking front to back. Get four strong boys, 2 on each rear tire, and rock that bugger front to back. This will also work to free a clutch that is stuck to the plate if you block down the pedal, but that is a different problem :-) I also recommend changing the crankcase oil as soon as you get it warmed up after starting her and then again after 10 hours of running. You want to get all the gunk out and the rust particles too.
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|