|
Tractor Talk Discussion Board |
Re: Re: Re: Re: SATOH BULL SHUT RIGHT DOWN
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by thanks larry and others about the satoh bull on November 12, 2000 at 18:10:49 from (208.237.82.28):
In Reply to: Re: Re: Re: SATOH BULL SHUT RIGHT DOWN posted by larry on November 05, 2000 at 17:10:30:
Well I tore the whole tractor in half and pulled off the rear casing-down inside towards the bottom was a broken 30 tooth gear that engaged the 4 wd in and out. Two teeth were broken-it must have been the pieces jamming in the other gears- I washed it all out-the only problem about getting it back is the preload calculations have me a bit baffled-but I should get by.Also for the record-I called down to PA. for the part-its only a 3 or 4 inch gear they want$224.00 for it. Just for comparison I called Kubota and their reply was that that is what there's would go for as well- so I guess that not all satoh parts are outrageous and not all are difficult to get. Now when doing bushhogging with a 4 ft bushog should I always be in the lowest gear goin slow? and I probably shifted into 4 wd without letting it mesh in completely-are there any other suggestions about how the gear broke---thanks so much again- Jasper James.
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
