Tractor Talk Discussion Board |
Re: Re: 3-point hitch -- category 2 vs category 1
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Truck on November 13, 2000 at 14:43:20 from (172.152.123.237):
In Reply to: Re: 3-point hitch -- category 2 vs category 1 posted by LazyHorse on November 13, 2000 at 09:36:53:
What will work well for the toplink is to use a Category one end threaded into your category two toplink. The el cheapo toplinks all seem to use the same threads. Of course bushings might be cheaper but if you have both Cat one and two tractors you might have the toplinks around. If you have a Ford with the replaceable lift arm balls all you need to do is switch to Cat. 1 balls. This would be on a 2000/3000/4000/5000 series, not on the older ones.
Follow Ups:
Home
| Forums
Today's Featured Article -
Restoration Story: Fordson Major - by Anthony West. George bought his Fordson Major from a an implement sale about 18 years ago for £200.00 (UK). There is no known history regarding its origins or what service it had done, but the following work was undertaken alone to bring it up to show standard. From the engine number, it was found that this Major was produced late 1946. It was almost complete but had various parts that would definitely need replacing.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|