|
Tractor Talk Discussion Board |
How to Pull Safely?
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by David A on November 21, 2000 at 07:35:44 from (208.237.135.21):
As a part time tractor operator around my property I am very interested in safety. How can I set up my Super A to pull stuff like skidding logs out of the woods and be assured it cannot wheelie flip?
I'd like to know it will just stall out or spin wheels if the load is too much. I know that pulling from a point below the axle (drawbar) is best. I've also heard a long drawbar extending backward helps because the lever action works against a rising front.
At tractor pulls I've seen the front rise about a foot or so and seemingly reach equilibrium with no real concern by the operator.
Could someone explain the mechanics of all this to me to help me make a safer setup?
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
