Posted by Will Herring on August 23, 2009 at 19:22:03 from (173.53.176.56):
In Reply to: Allis Chalmer shift posted by El Toro on August 23, 2009 at 17:51:48:
Dennis Matchell said: (quoted from post at 20:51:48 08/23/09) How do I reinstall a shift tower on a Allis Chalmers WD 45.Not just the shift lever?
Well first off, you need to make sure the shift forks are all in proper alignment. It fits on most easily in Reverse, I believe. You just need to feel it out and slide it back on, there's an art to it, and it will likely take a couple of tries.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
