Posted by xcsp on August 24, 2009 at 05:36:06 from (205.188.116.19):
Hello I have a new holland 469 haybine with conditioner ,well i was making my second cutting and started to have trouble with it .
I was missing a lot of hay and would get clogged up at the cutter bar , would have to go in reverse to clear it thaen it would cut good and do the same thing again.
I noticed my belt on the cutter bar is worn and needs replaced ,it is out of adjustment , also I would have to go so slow to cut the hay it took me forever to finish my field.
Any one know how to correct this problem ?????????????
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
