Tractor Talk Discussion Board |
8N hood repair
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Henry Rubach on December 11, 2000 at 23:20:24 from (216.112.142.17):
I have several 8N's that I am restoring (9 to be exact) and found it difficult to bondo rusted out spots along the bottom part of the hood. Actually the bondo part is easy...it's trying to get the round part sanded back to the original contour that's difficult. I came up with a neat trick I'd like to share. Find an area along the bottom of the hood that's in good shape and lay some masking tape on about a 6 or 8 inch area. Do not overlap any edges of the tape. Mix up a good blob of bondo and slap it on pretty thick. After it cures, lift it off, trim the edges with a hack saw and you have a nice template. Next, apply bondo to the rusted out area and stretch some Reynold's plastic wrap over it. Before it cures, put the template on it and press down. Try to squeeze as much excess bondo out as you can. Remove the template and let it cure. Peel off the plastic. Very little sanding is needed to make a perfect repair. You may want to experiment with different template sizes, etc. depending on how much repair is needed. This technique should work for other hoods as well. Any comments would be appreciated. Thanks and have a Merry Christmas!
Follow Ups:
Home
| Forums
Today's Featured Article -
Usin Your Implements: Bucket Loader - by Curtis Von Fange. Introduction: Dad was raised during the depression years of the thirties. As a kid he worked part time on a farm in Kansas doing many of the manual chores. Some of the more successful farmers of that day had a new time saving device called a tractor. It increased the farm productivity and, in general, made life easier because more work could be done with this 'mechanical beast'. My dad dreamed that some day he would have his own tractor with every implement he could get. When he rea
... [Read Article]
Latest Ad:
2022 John Deere 5045E, 4wd, front end loader and 3rd function with grapple. 120 hrs, 55k new, must sell
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|