Tractor Talk Discussion Board |
Re: Re: Re: Re: electrical system clean-up
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Denny on December 15, 2000 at 07:34:29 from (206.230.112.30):
In Reply to: Re: Re: Re: electrical system clean-up posted by Al on December 14, 2000 at 18:11:12:
I can't improve on any of this, but I'd suggest that instead of crimp-type connections, you use solder and heat shrink tubing instead. It's a bit slower to assemble that way, but it will save a LOT of time down the road a few years, tediously cutting those crimp connectors out and replacing them because they corroded up. I know some folks have good luck with them, but I ain't one of 'em, and I quit using the things except for emergency roadside repairs a while back. Life's been more fun since. Best of luck, Denny
Follow Ups:
Home
| Forums
Today's Featured Article -
Upgrading an Oliver Super 55 Electrical System - by Dennis Hawkins. My old Oliver Super 55 has been just sitting and rusting for several years now. I really hate to see a good tractor being treated that way, but not being able to start it without a 30 minute point filing ritual every time contributed to its demise. If it would just start when I turn the key, then I would use it more often. In addition to a bad case of old age, most of the tractor's original electrical system was simply too unreliable to keep. The main focus of this page is to show how I upgr
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|