Posted by Dan Swanson on September 09, 2009 at 15:12:04 from (63.172.255.203):
I have a good pair of michelin 480/70 R34 radials on my 806 70% tread or so. They are just about 1" taller than a 16.9 X 34 bias per spec. I would like to run clap-on duals from time to time to improve floatation. I have a like new 16.9 x 34 bias tire but I can't for the life of me find a desent 2nd bias. Cheapest chinese tire I can find is right at $600. I have located a near new 16.9 R34 chinese radial tire for $250. I know I should match the tires as close as possible but would it cause any problems by running the bias and a radial on the duals? The tractor's heaviest load is a 14' chisel/sweep used for summer fallow which isn't much of a load compared a 4 bottom plow I have. Thanks, Dan
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Tractor Profile: Farmall M - by Staff. H so that mountable implements were interchaneable. The Farmall M was most popular with large-acreage row-crop farmers. It was powered by either a high-compression gas engine or a distillate version with lower compression. Options included the Lift-All hydraulic system, a belt pulley, PTO, rubber tires, starter, lights and a swinging drawbar. It could be ordered in the high-crop, wide-front or tricycle configurations. The high-crop version was called a Model MV.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
