Posted by awhitva on September 15, 2009 at 07:40:34 from (196.201.218.218):
This message is a reply to an archived post by Rob K in Maine on September 16, 2008 at 18:21:56. The original subject was "How to determine year of IH 2bottom plow".
Hey Rob, if you are still out there, I read the number from old post on your plow bottom and my Genius plow has the same number(510378R1)on the back of the points. I am wondering if your moldboards possibly have this number 510374R1? If so, we have the same plow bottoms and they are a little unusual for a Genius plow. This is what I know about them, according to someone who looked up this number: It is 14" HSB (high speed bottom), parts book says "similar to BA series", built 1946 to ?, and its from the Chattanooga Plow Works - an IHC subsidiary.
I can get parts for whole plow, except for these bottoms. I need to replace one of my moldboards, which is cracked. Have you possibly found a parts source for your bottom parts (shares, moldboards, points, etc.)?
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
