Posted by maplehillfrm on September 16, 2009 at 09:52:47 from (170.215.198.237):
chrisco said: (quoted from post at 16:52:49 07/14/09) Sunday I was running my deutz dx90 for raking and was going along and I stopped to check the dryness and noticed that the vent tube was blowing out oil so I stopped and checked the oil and it was full of diesel so I dropped the oil right there and put new in. After 2.5 hours it had not gone higher then what I had put in. So i dont know what happened because it was not missing and running fine. My suspition is the the key did not get fliped off of preheat or II on the key switch. Beacuse the kids "both close to retirement" left it there while running it for a couple days while I was on vacation? Or could it be my front seal on the pump is leaking? I dont think a have a leaky injectior.
Your thought would help!
Chrisco
I just went through this with my 2500A international ,,not the same tractor but , I pulled my hair out, changed teh seal in teh pump twice, once because it was believed to be the culprit, teh second time because it was still leaking into the crankcase after replaced..
the second time the seal was pushed out a bit,and a injector shop said it looked like a clogged return line or the check valve in teh bottom of the tank,,
I had a bad check valve .. now no fuel in the oil, check you return line , or see if you have a check valve on the return line into the tank,, but my return line is lower than the pump,,, good luckpat
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Grain Threshing in the Early 40's - by Jerry D. Coleman. How many of you can sit there and say that you have plowed with a mule? Well I would say not many, but maybe a few. This story is about the day my Grandfather Brown (true name) decided along with my parents to purchase a new Ford tractor. It wasn't really new except to us. The year was about 1967 and my father found a good used Ford 601 tractor to use on the farm instead of "Bob", our old mule. Now my grandfather had had this mule since the mid 40's and he was getting some age on him. S
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
