Posted by DRL on September 18, 2009 at 19:51:41 from (24.206.128.104):
In Reply to: corn binder posted by LEH on September 18, 2009 at 05:20:25:
Just finished tonight binding our club's corn for our show next weekend. Will run most of it through a husker shredder, then shell it with a JD corn sheller. May grind some up with the Letz mill. When they planted this corn, they thought that the planter wasn't dropping the seeds properly, so they went back over several rows. You guessed it! Had corn three to four across in the rows. The old worn out binder didn't like that one bit. Had to unplug it several times. Should have cut the corn earlier. Stalks were dry and brittle. Have never had a problem in the past with this binder, but the extra corn in the rows this time made it a memorable occasion.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.