Posted by LEH on September 22, 2009 at 10:50:48 from (65.25.139.234):
In Reply to: Re: trip rope posted by Mike Groom on September 22, 2009 at 06:24:22:
Well, I guess I'm not the only one then !! My ride was by accident. Our barn was close to the road. Dad pulled the haul rope with a BF Avery "A" up the road. He could not see in the barn. Grandpa would wave for him to stop & then pull the trip. I was about 6 or so when I wanted to pull the trip rope. Grandpa stood by the door way to signal Dad. I wrapped the trip rope around my arm getting ready to give it a good jerk, but I didn't leave enough slack in the rope. As soon as the fork took off, so did I. Up to the track and zoom to the east end of the mow. I still do not like high places to this day !! This would have been about 1956. I still have the hay fork!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Nice Marvel Schebler DLTX 8 bronze body carburetor For 1934-1936 unstyled A tractor.Serial No.410000-42850. All restored and ready to use.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.