Posted by Osterbur on September 26, 2009 at 09:36:58 from (66.253.151.249):
In Reply to: Geothermal posted by Jim from PA on September 26, 2009 at 05:07:17:
I did some research on this last year. I think the max temp you can get is 140 F with geothermal. I also have a boiler. So I set the boiler temperature limit at 140 degrees to see how the system would perform. The result was that on those cold windy nites when demand was highest, the burner would shut off at 140 degrees water temp but the circulator would continue to run about 2 or 3 minutes and then the burner would come back on. In theory this is a better way to do it because you will get more even heat distribution. I found that to be true but only slightly. My furnace is oversized so I was wanting to determine heat loss as I was thinking of replacing the boiler with a high efficiency model. I measured the burner on time when the thermostat called for heat until the thermostat was satisfied and then converted to a percentage. My average burn time was about 25%. Meaning 15 minutes of burn for every hour.
Now I know I can get along fine with 140F water on the coldest nites/days of the year. I live in east central Illinois. I have a 1600 sq ft house with full heated basement. Boiler is 140K btu output.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - The Ferguson System Principal An implement cutting through the soil at a certain depth say eight inches requires a certain force or draft to pull it. Obviously that draft will increase if the implement runs deeper than eight inches, and decrease if it runs shallower. Why not use that draft fact to control the depth of work automatically? The draft forces are
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
