Just had one done two weeks ago. Will need the other one done too. The surgeon didn"t want to do both at the same time unless it was a life and death situation. Also the pysio therapist says its not an easy situation trying to bring both knees back to full capacity at the same time.Age also makes a deciding factor in this.(I"m 56) With one at a time, even though the other one is wore out it is still stronger and helps with getting around. Do the exercises that they tell you to do as often as they say.this helps with the reducing of the scare tissue and also to get as much mobility out of the new joint as possible. Use lots of ice packs on the leg.Also elevating the leg will also help reduce the swelling.With a total knee replacement, the new knee is ready to go as soon as it is installed. It will carry full weight. Its only the cutting and the stitchs and swelling that will hinder you. Also there will most likely be lots and lots and lots of bruising. Had mine done on the 21st Sept and 90% of the brusing is gone now. I"m so releived to have had this one done to relieve the pain, that words can not describe the good feeling. Good luck and keep us posted. Brian
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
