My wife has had both of her knees replaced, one each year several years ago. She had a real rough time with both surgeries/rehabs, probably mostly because she cannot take much in the way of pain meds. We used a huge amount of ice to help her pain for some time after the surgeries. It took her months both times to get so she could get around fairly well, and that was with the other kneed either not worked on yet or pretty well healed. I cannot imagine how she could have recovered anywhere nearly as well if they had been done at the same time. She is doing quite well with the replacement knees now, with almost no knee pain, but that first year for each knee was sure no picnic.
Her surgeon would not do both at one time either. A few years before, he had lost a patient that had insisted on having both done at once. The doctor said never again.
On the other hand, a friend of mine had both knees done at once with no problems. In fact, less than a month after the surgery, he was climbing stairs alternating feet and no longer using a cane. But my guess is that he is an exception, extremely healthy except for worn out knees.
It depends on how well you heal, how well you take pain, and probably a bit of luck. If I ever need new knee or hip joints, I will only do one at a time, but that is just my opinion and I am pretty conservative about most anything.
What does your doctor recommend? Hopefully the doctor has done many similar surgeries and has a good handle on what works well and what isn't so good. I would listen to what the doc says, and then probably still decide to only have one done at a time. Good luck!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Choosin, Mounting and Using a Bush Hog Type Mower - by Francis Robinson. Looking around at my new neighbors, most of whom are city raised and have recently acquired their first mini-farms of five to fifteen acres and also from reading questions ask at various discussion sites on the web it is frighteningly apparent that a great many guys (and a few gals) are learning by trial and error and mostly error how to use a very dangerous piece of farm equipment. It is also very apparent that these folks are getting a lot of very poor and often very dangerous advice fro
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.