Posted by ScottyHOMEy on October 11, 2009 at 08:33:27 from (71.241.207.111):
In Reply to: timing marks A Farmall posted by Gary Spear on October 11, 2009 at 07:36:43:
The way that motor is timed up, the single punch mark aligns with a single mark on the gear at the front of the crankshaft. The double mark is for your governor and ignition drive gear. IIRC the mark is aligned with a notch on the cam gear, and the mark on on the gov/dist gear is on a tooth. Even if it's the other way around, the marked tooth and notch should mesh when the motor is at TDC on 1 and 4. It's possible that you're a tooth off on the bottom, but I'd consider that last. More likely you're close but not exactly at TDC on the crank.
According to the parts book, there was a change made in '45 to the governor shaft bumper spring and the pin at the front end of it. They then offered a single, separate kit of both spring AND pin that could be used to replace either. If you swap the longer spring in, I'd swap the pin as well. If your existing weights are good, there's no need to change them out.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Show Coverage: Journey to Ankeny - by Cindy Ladage. We left Illinois on the first day of July and headed north and west for Ankeny, Iowa. Minus two kids, we traveled light with only the youngest in tow. As long as a pool was at the end of our destination she was easy to please unlike the other two who have a multitude of requirements to travel with mom and dad. Amana Colonies served as a respite where we ate a family style lunch that sustained us with more food than could reasonably fit into our ample physiques. The show at Ankeny
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
