Posted by Paul in MN on October 12, 2009 at 08:53:19 from (207.224.93.19):
In Reply to: MM335 1957 Utility posted by Ken-in-ky on October 11, 2009 at 11:07:14:
We had a 335 Utility once, but didn't need to O'H the engine. I have other MMs that I have OHed. There don't seem to be complete kits available like you might find for the Farmalls, JDs and Fords. I sourced parts from a very knowledgeble engine parts supply house. Rings, bearings, gaskets, etc were all available. But the availability to find pistons is questionable. On many MMs, you are comitted to using the old pistons or finding other old or NOS if someone has any. For my work on the 206 cu inch (same family of engine, but not OHead valve like yours), the machine shop miked the valve and found with slight modification that the valves from a Chev 350 engine would work.
Maybe find a MM collector guy in your area, and he will probably be glad to share some tips with you, especially as to where to get parts and machine shop service. One of the well respected parts suppliers is Welters of Verona MO. phone #417-498-6496. If a lady answers, trust her knowledge, she knows her parts.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
