T_Bone said: (quoted from post at 23:15:14 10/12/09) Time too look for a cordless impact wrench. Anyone bought one that's worth a darn?
Uses:
For automating my trailers landing gear. Maybe 5 times a year. 20k Bulldog landing gear, but boy does she roll hard under full load. If I used the trailer more. I'd change over too hydraulics and be done with it.
Changing flats on the road. I keep good tires on at all times. Been a few years since my last flat.
I'm thinking a cheap HF or my existing Milwaukee 1/2", 18v cordless. I'd hate to mess up my good Milwaukee.
T_Bone
Any one that depends on a air are electric impact to do a final tightening on a wheel is going to some day have a customer come back with a loose wheel,,, that's not good.
You can go with a cheaper tool and break the lugs by hand if need B,,, no extra work cuzz you need the pull bar to do the final tightening.
I keep a elcheapo craftsman around to run the nuts off and on and bar the lug nuts by hand for the final tightening.
Batteries last a long time,,, way longer than if used in a drill.
Snap-on are not worth the extra money,,, they now do not make their own air are battery tools,,, why cuzz when they made them they were junk so they outsource them now,,, if someone has a good'n its probably made in china
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Restoration Story: 1964 JD 2010 Dsl - Part 2 - by Jim Nielsen. Despite having to disassemble the majority of my John Deere 2010's diesel engine, I was still hopeful I could leave the engine-complete with crankshaft and camshaft-in the tractor. This would make the whole engine rebuild job much easier-and much less expensive! I soon found however, that the #4 conrod bearing had disintegrated, taking with it chunks of the crankshaft journal. As a resul
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
