When I raised pole lima beans that mower made short work of the vines. I bought it used in 1976 when it was 2 years old. It came with a sulky, but I sold it since I never used it. I rebuilt the engine about 15 years ago. The cylinder had to be bored oversize, crankshaft had to be ground undersize .020". I think the exhaust valve had to be replaced too. I reused the main bearings. With a new piston & rod it was like new again. My neighbor had an area at the rear of his proptery was overgrown and he was trying to clear it with a Weedeater. I told him I had something that would make cut that brush like butter. He said to get it and I cut it down in about 20 minutes. He wanted to know what I wanted for doing it and I told him what he thought it was worth. He gave me $50.00. He was soaking wet from being out there with his Weedeater as it was in the 90's. Some of these came with battery start and I could've put that on this mower, but its easier just to use the garden tractor to start it. The mower engine has a lot of compression and is hard to pull with a rope, even though I still start it with the rope at times. I still have some spare parts that came with it. I have 5 or 6 31" blades. Some have the the sickle bar mower sections on them that's been drilled to remove the rivets. Hal
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
