Posted by thompsonrc on October 19, 2009 at 04:15:36 from (208.103.136.44):
greygoat said: (quoted from post at 07:47:30 01/08/09) Try www.smokstak.com, its and antique gas engine
and steam engine site. There are several different
catagories, including one on magnetos, where you
can ask questions, and lots of knowledgeable
people answer.
I have a WICO, master parts book, about 6 inch"s
thick, gives directions on how to do it, and specs
for different engines. I"ve never done it, but
think it"s just a matter of adjusting the stops
that trip the impulse. A test stand may be
required to do it right. My e-mail is open, send
an e-mail and i"ll copy those pages and forward
to you.
Hi. I have an Allis B with this WICO XH1113 mag and it does not run smooth. Can you scan in the pages of your book that refer to this modifications to make it work with an Allis B? I do not think my mag was set up correctly in the first place.
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.