Posted by Paul in MN on October 21, 2009 at 13:20:09 from (71.210.158.89):
In Reply to: pics posted by LOU from Wi. on October 20, 2009 at 17:24:17:
Wow!, that is nice looking wood. And what a gift to have a son who will help cut and haul.
I am a bit NW of Minneapolis, where the developers are slashing the he!! out of beautiful wooded areas. So I get all the wood I want free, but I must drag, cut, haul and split mostly by myself. I do have a son who also heats with wood (outdoor boiler) and we sometimes work together making wood. I have a Tarm boiler in walkout bsmt that makes house heat and domestic hot water. I installed it in 1977 and have only used an average of 100 gal of oil (backup) each winter.
I have health problems from Lyme disease, so the firewood is getting harder to make each year. I have always loved the ideas of providing for one's own family needs, seeing the oil companies and the Arabs getting very little from me, and Uncle Sam not getting a piece of this work to put in his pocket. (When you make no $$, you have no tax on it, when you use modern convenience fuels, you earn the $$ first, then U.Sam gets first cut, and then you get to pay the oil robbers with what is left over). That thought process keeps me going even when the body is not willing.
Although there are better burning woods available here, I have unlimited access to Elm that has died from Dutch Elm disease. When split and dried for 1 year, it gives very good heat with enough coals and very little chimney creosote. Oak usually produces more creosote in my boiler and chimney.
I do have a 20 Ton hydraulic splitter that has earned its keep many times over (made in Wisconsin!).
Stay warm, and check the smoke pipe to the chimney as you begin the heating season. Be Safe!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - Third Brush Generators - by Chris Pratt. While I love straightening sheet metal, cleaning, and painting old tractors, I use every excuse to avoid working on the on the electrics. I find the whole process sheer mystery. I have picked up and attempted to read every auto and farm electrics book with no improvement in the situation. They all seem to start with a chapter entitled "Theory of Electricity". After a few paragraphs I usually close the book and go back to banging out dents. A good friend and I were recently discussing our tractor electrical systems when he stated "I figure it all comes back to applying Ohms Law". At this point
... [Read Article]
Latest Ad:
1945 Farmall wide body gas with pto and front plow. Runs good but needs new points.
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
