Posted by Paul from MI on October 21, 2009 at 19:55:56 from (204.106.244.65):
In Reply to: Fixing Spring End posted by Brian-Ont on October 21, 2009 at 07:12:08:
DON"T attempt to reharden or retemper the end of the spring, unless you have a lot of experience in metalurgy. You will most likely end up with a hardened, untempered section of wire that will break easily. Most oil tempered spring wires are hardened and tempered to approx. Rockwell c 45-48. Unless you can carefully control both hardening and tempering temperatures, and have a means of controlling the surrounding atmosphere to prevent decarburization you are wasting your time anyway. I assume that you are speaking of a 3/8 diameter wire spring, so it won't bend easily to form a new hook. You may have some success by heating the area to be bent to form a new hook to a very dull red, bend it to shape while hot, then letting it air cool. The spring likely broke in the first place because it was highly stressed or had a rust pit that created a stress riser. Either way it may break again fairly soon. If it was mine and it broke on Sunday afternoon I'd give it a try to get going again. Replacement is the best alternative. I know this is kind of long, but I spent 45 years designing and making springs and spring machinery so I've had a little experience. Good luck with it. Paul
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
Today's Featured Article - 12-Volt Conversions for 4-Cylinder Ford 2000 & 4000 Tractors - by Tommy Duvall. After two summers of having to park my old 1964 model 4000 gas 4 cyl. on a hill just in case the 6 volt system, for whatever reason, would not crank her, I decided to try the 12 volt conversion. After some research of convert or not, I decided to go ahead, the main reason being that this tractor was a working tractor, not a show tractor (yet). I did keep everything I replaced for the day I do want to restore her to showroom condition.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.