Posted by Dave from MN on October 23, 2009 at 17:01:41 from (96.24.95.216):
Posted a few days about picking up a Kewanee chisel plow. Well, I did. I love it? Got her home, had to add a cylinder, pump up a tire, grease a few zerk's, and was feild ready. Top side of shovels never seen dirt, bottem side like new. I really am happy with the job it did. Just came back from a feild run. Did great, this is that feild I had to add lime and had hard pan issues. My "well fed" oli 1750 pulled it just fine, 4th low, it did pull it in direct, but low seemed to be the better speed, and I did sink it down quite good in spots to see if she had the mustard. Tilled width is about 12 feet. Very happy with my $450 purchase!!
We sell tractor parts! We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy
TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V.
