Tractor Talk Discussion Board |
Re: planting Brome hay
[ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Mike Aylward on January 16, 2001 at 20:21:23 from (207.177.31.136):
In Reply to: planting Brome hay posted by Doug on January 16, 2001 at 12:33:25:
Doug, I'm not sure where you are located, but here in northeast Missouri you would not likely get brome to start in the seeding year. It is very slow to get going and frequently doesn't grow much until the second year. Many around here in your situation would "burn down" the ground (either chemically or by actual fire) and then seed oats with brome mixed in. You don't have to seed the oats very heavy, either, just enough to get the ground covered, probably around a bushel or slightly more. The oats will keep the ground covered until the brome can get started. If it were mine, I don't believe I would try straight brome as the weeds will take things before the brome can get going. Hope this helps. Mike
Follow Ups:
Home
| Forums
Today's Featured Article -
Earthmaster Project Progress Just a little update on my Earthmaster......it's back from the dead! I pulled the head, and soaked the stuck valves with mystery oil overnight, re-installed the head, and bingo, the compression returned. But alas, my carb foiled me again, it would fire a second then flood out. After numerous dead ends for a replacement carb, I went to work fixing mine.I soldered new floats on the float arm, they came from an old motorcycle carb, replaced the packing on the throttle shaft with o-rings, cut new ga
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|